What Are Goulds Well Pumps

This is a pump that uses the pressure of water to push the top up, which in turn forces the water out of the attached hose. This type of pump was more common during WWII than it is now. However, there are still hundreds if not thousands of these old pumps in use today! The original manufacture of the pump was by a company named Gould. In the 1930s, this pump was used to water orchards in California by pumping from a stream or river that ran through them. Since most people had no electricity back then, these pumps were run by a 4-cylinder gasoline engine which is why they are sometimes referred to as “gas well pumps.”

The pump is driven by the suction created as the piston goes up and down in the cylinder. This type of pump was used for many years but has been replaced by electric pumps that are easier to start, do not require a separate gasoline engine, and can be used inside buildings.

One of the most common types is an electric-powered submersible loop pump which can be installed in either a basement or crawl space. It operates by drawing water from the ground into an underground chamber where it is pumped up to the surface through small diameter pipes called suction lines. These high-capacity wells are often used as backup systems during power outages because they don’t require electricity to operate as other traditional models do. The article will help you learn more about these Goulds well pumps.

What are the Different Types of Well Pumps?

As mentioned above, well pumps refer to the pump located in your water well. As for different types of pumps, there are three main kinds that you can choose from jet pumps, submersible pumps, and vertical turbine pumps. Submersibles are often used as deep-water wells because they don’t have any moving parts located outside the well’s casing. As a result, there’s less risk for contamination and damage compared to other models out there. However, they tend to cost more than the other two.

Jet Pumps

Unlike submersibles, jet pumps have a few moving parts that are located outside the well casing. This is why some homeowners refer to them as one of the loudest types of pumps out there. When it’s running, you won’t be able to hold a conversation in your backyard since it can get extremely noisy. If you’re having trouble sleeping at night and live around a busy area like a golf course, high school, or airport, this is not the model for you.

Submersible Pumps

Work by drawing water into a pipe that runs down the center of it. As it enters the pump, the water is forced up and out through another pipe on top where you can then use or store it. By and large, they’re fairly quiet and take up less space than the others. However, they don’t work too well in wells with a high volume of sand or gravel so be sure to ask your installer about any potential problems before getting one. While this type of pump does require electricity, there are some models out there that can run off an established well and solar energy instead.

Vertical Turbine Pumps

This last type is also known as a “vertical turbine submersible” pump, in which the water enters at the bottom and is forced out through another pipe on top. It doesn’t matter what direction it’s going since this system functions much like an old-fashioned egg beater. One advantage to this model is that it allows for easy winterization (i.e., you can blow out the system with compressed air instead of having to drain it). This type of well pump costs more than submersibles but less than jet pumps. It has an advantage over the other two because it’s completely submerged which means there’s no risk of contamination or damage. As a result, you won’t need to worry about rusting, corrosion, and other issues caused by debris getting in the well.

Although these are the four main types out there, there are also well pumps that run on solar power which might be perfect for rural areas that don’t have access to electricity yet. If you’re wondering, “what is a well pump?”, hopefully, this article has helped answer that question.

What are the Advantages to Owning a Goulds Well Pump?

Well pumps offer homeowners many advantages like durability, reliability, and longevity. Unlike other models, they're more resistant to wear and tear since the lack of moving parts keeps them from breaking down as often.

They are also very durable meaning that you can go years without needing any repairs done on them. Since they operate under high pressure, submersible pumps are even reputed to last up to 50 years although 20 is probably a more accurate estimate.

iMAGES

tITLE

BUY

GOULDS Pumps GT15 IRRI-Gator Self-Priming Single Phase Centrifugal Pump, 1.5 hp, Blue

FeatureGOULDS Pumps GT15 IRRI-Gator Self-Priming Single Phase Centrifugal Pump, 1.5 hp, BlueDescription

Goulds Pump J5S Shallow Well Jet Pump, 115-230 volt, 1.2 hp

Goulds J5S Shallow Well Jet Pump, 115/230 volt, 1/2 hp

Goulds J7 Convertible Jet Deep Well Pump - 115V 230V - 3.4 Hp

Goulds J7 Convertible Jet/Deep Well Pump - 115v/230v - 3/4 hp

Goulds-J10 Double Nose Deep Well Goulds-Jet Pump 1HP

Goulds-J10 Double Nose Deep Well Goulds-Jet Pump 1HP

Goulds J15S - 1.5 HP Shallow Well Jet Pump

Goulds J15S - 1.5 HP Shallow Well Jet Pump 

Goulds JRS5 Shallow Water Well Jet Pump

Goulds JRS5 Shallow Water Well Jet Pump, 1/2 HP, Single Phase, 115/230 V

Goulds GT20 2HP Sprinkler Irrigation Pump

Goulds GT20 2HP Sprinkler Irrigation Pump With Outdoor Motor Cover

Goulds VJ10 60HZ Vertical Deep Well Pump

Goulds VJ10 60HZ Vertical Deep Well Pump 1HP 

Goulds Well VJ07 Vertical Deep

Goulds VJ07 Vertical Deep Water Well Jet Pump, 3/4 HP, Single Phase, 115/230 V

Goulds J5 Convertible Jet, Deep Well Pump

Goulds J5 Convertible Jet, Deep Well Pump - 115v/230v - 1/2 hp 

Some Things to Consider Before Buying A Goulds Well Pump

Although many homeowners don't think about it too much before purchasing their well pump, there are a few things you'll want to keep in mind before making a purchase. For starters, be aware of your water pressure because this is essential to how well the pump functions. If you have low water pressure, this will limit how much water the pump can bring up which means fewer gallons of fresh clean H20 for you to drink, cook with and bathe in.

Also, if you don't have enough water coming into your home, your bathrooms won't be able to flush properly, your clothes won't get clean in the wash and you may even have problems with your dishwasher.

Think about how much water you need before deciding because this will affect both your budget as well as your choice of pump models. If for instance, you live alone but have four people in the house during the weekends, you may want to buy a smaller pump which will also save you money. 

Know the Difference Between Residential Pump to Commercial Pump

Residential well pumps are used to supply water to property while commercial pumps are used for farms, ranches, and other large establishments. In addition to this, there is a difference in pressure as residential models typically deliver up to 40 PSI while commercial ones can pump out as much as 150 PSI.

In addition to these differences, commercial pumps are typically used for more heavy-duty things like irrigation where they have to deliver large quantities of water over long distances. On the other hand, residential pumps are designed with features that make them easier to transport so you can bring them indoors when it's raining without having to worry about damaging electronics or settings.

Finally, commercial pumps can cost up to three times more than their residential counterparts so they only make sense for those who need the extra power and durability.

To decide whether a residential or commercial well pump is best for you, think about the water pressure in your home. If it's over 50 pounds per square inch (PSI), a commercial model might be better since it can withstand more pressure and therefore provide you with more gallons of clean water throughout the day, week, and year.

On the other hand, if the PSI in your home is less than 50, a residential well pump can help you get clean water while staying within your budget. Although commercial well pumps might cost more initially, they'll save you money in the long run by bringing up greater volumes of fresh H20 and reducing water waste. 

Ideal Size of Goulds Well Pump

The right size of well pump for your home depends on a combination of things including the type you're using, how much water you typically use, and what kind of pressure is coming into your residence. For example, if you have a low household water pressure or want to draw more gallons at once, then choosing a submersible model that's greater than 1 horsepower in size is the best choice for you.

On the other hand, if your water pressure is decent but you want to reduce any wear and tear on your pump then using a self-priming model that delivers between 1/2 and 2 horsepower could be a good idea. In addition to all this, consider how much water your household uses day to day as this will affect how often you need to pump more.

Both commercial and residential well pumps are good choices, depending on the water pressure in your home, how much water you typically use and what kind of durability you need. Be sure to consider all these things before deciding this will save money and time in the long run.

What can be done to ensure the longevity of your Goulds Well Pump

The longevity of any submersible well pump is highly dependent upon the care given to the installation. This starts with choosing a competent contractor, then following through with professional recommendations for the location and selection of casing material that will provide maximum protection for the quality of water. The site should be free from obstructions that can cause vibration or turbulence in the water column. Placing the pump too low in the well can result in premature wear on both the mechanical seal and impeller.

Good maintenance practices are extremely important for maximizing the longevity of your submersible well pump. The frequency or "schedule" of cleaning should be determined by how dirty it is when tested before backfilling. The more frequent and thorough the cleaning, the better. It is also important to remember that air frequently gets into the water lines when a pump stops running. Not allowing the line to refill with water before starting up again can cause serious damage to both the suction and discharge sides of your pump.

To get an estimate on how much life you may have left on your current pump, run it for approximately one minute. If the total head is more than about 10 feet, or if you pull less than 5 gallons per minute (gpm) with a 20-foot vertical lift, then your existing pump may be reaching the end of its useful life. For best results, contact us to schedule an onsite service and pump performance test.

For the best long-term results, we recommend that you install a new Goulds Water Technology Pump. They use magnetic coupling technology which leads to quieter operation, increased flow rates, and provides more efficiency than conventional designs.

Why you should consider using a Goulds Well Pump

The Goulds drive mechanism is open-centered, so there is no mechanical seal to replace. We use a magnetic coupling for quiet operation and long life, which means no couplings or sleeves to wear out. Our pumps are self-priming and the sealed motor compartment protects your pump from external contaminants such as dirt, leaves, and debris.

[adinserter block="3"]

Air chambers are included as part of the casing system, which keeps flotation to a minimum and allows for free circulation. Goulds Pumps have been designed from the ground up to be installed into open-cased wells, rather than a pipe connected directly to a well. This arrangement minimizes installation costs and time while providing better performance and longer life. Goulds Pumps are designed for minimal flow restriction and therefore, they can work in higher lifts than other pumps on the market. The high lift capability of our pumps allows installation in deeper wells with lower pump energy requirements. Our Goulds Pumps come standard with aluminum wet-end construction, which offers better corrosion resistance over iron wet-ends. The Goulds aluminum wet-end will not rust or corrode and it lasts longer than other wet-ends. Our motors, impellers, and couplings are all designed to be maintenance-free for long life. We offer custom manufactured (CMM) wet-ends as an option that can handle high amounts of solids such as sand and grit. Our pumps can handle up to 10% solids content in the water being pumped, significantly more than any other pump on the market. Goulds Pumps are also designed as a completely open system, allowing for free-flowing, high performance, and long life with no internal operating restrictions.

With over 30 years of experience in the water well industry, Goulds Pumps is committed to building high-quality pumps that are capable of handling the most difficult of applications. Our pumps are available for both new wells and reconditioning of existing wells, so you can always rely on Goulds Pumps to maintain the performance of your water well system today and in the future.